Wednesday, June 19, 2019

Thermodynamic and Fluids Report Coursework Example | Topics and Well Written Essays - 1750 words

Thermodynamic and Fluids Report - Coursework ExampleIn the second part we shall use a pitot static tube to determine the behavior of air flow.The prefatory principle of both the pitot, static and pitot static tube is that the pressure of a flowing fluid will increase if it is brought to rest at a commove of stagnancy of the probe. If an assumption is made that if the flow in the fluid is similar to that of a gas, the velocity of the fluid will be much smaller as compared to the speed of sound such that the changes in the density may be overlooked (Bertin, 2002). Therefore, the fluid basically behaves like an incompressible fluid. The point of stagnation give the sack be located on the system and the streamlines can be bent past the body of the aircraft. The pressure experienced at the point of stagnation is referred to as the stagnation pressure. If the viscous effects experienced by the body are negligible, the difference between the stagnation pressure and the static pressure is usually relate to the dynamic pressure which is then related to the square of the velocity (Panton, 2005). Therefore, the velocity information is then converted to a pressure difference which can e measured by a measuring device for pressure such as the manometer (von Krmn, 2000).The static tube is composed of a cross particle surface with tubes and a manometer. The air flows across the cross section into the manometer where the density of air can be determined. The manometer allows for the determination of the static pressure, the dynamic pressure and the stagnation pressure of the fluid.The pitot static tube is a combination of the static and pitot tube. In this tube, the flow in the tube is axi-symmetric and within the vicinity of the nose. The pitot tube is then affiliated to one limb of a U tube manometer while the other limb of the manometer is connected to a tap made on the tube wall. twain the tap and the nose of the tube approximately on the same planes.An

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.